Embroidery Thread Fluffing Misunderstanding

Embroidery thread fluffing misunderstanding [Cross Stitching Lovers must see! ]

Embroidery Thread Fluffing Misunderstanding

According to the embroidery lovers reaction, in the process of embroidering cross stitch, the embroidery thread is easy to cause fluffing due to friction. dears, pay attention to the following points, which can effectively prevent the embroidery thread from fluffing!

1. It is easier to fluff up without embroidery loops than with embroidery loops. It is best to use an embroidery frame or embroidery loop to tighten the embroidered cloth as much as possible, so that the embroidery does not fluff and saves effort.

2. When pulling the thread, it is best to be perpendicular to the embroidery cloth, which can reduce the friction between the embroidery thread and the embroidery cloth. If it is difficult to embroider, the angle between the thread and the cloth should be as close as possible to 90°. If it is always at an acute angle, or even almost parallel to the embroidery cloth, it will easily damage the embroidery thread during friction.

3. Don't think that pulling the thread will hurt the thread quickly. In fact, the faster you move, the less you will hurt the thread. Some embroiderers said: Flying needle threading is the highest level.

4. It is best to choose a slightly larger needle, and it is better to stretch the hole a little bit, so that the friction of the embroidery thread is small when passing through. If a small needle is used, the embroidery thread will rub a lot. The thread is also prone to fluffing.

5. The length of the embroidery thread is preferably 50 cm, which can minimize the friction between the thread and the cloth.

6. If the embroidery cloth is not good, no matter how good the thread is, it will fluff. There is a layer of water-soluble slurry on the interlocking canvas, which is designed for the convenience of embroidery girls. After the embroidery is finished, it can be dissolved by regular soaking in water The layer of pulp on the surface can restore the soft feel of the Anger canvas after cleaning, and can effectively reduce the friction strength of the embroidery thread.